2.6b2

[Stuart Murray]

Copy cell properties doesn't seem to work correctly either, I am selecting a cell to copy to make a new one and it is not using the correct cell

Stu

[Corey Cooper]

Hi Corey,

Did you have a look at the Events Messages not flashing bug?  I was checking it again today and have noticed that status messages are flashing ok, so it seems to be just the events messages that are not flashing.

Regards
Stuart

I did, thank you.  It was a bug specifically in the event code, so the status messages weren't affected.  Of course, that's if I remember correctly.  It all starts to blur after a while, especially at the pace I'm working on it at the moment.

[Corey Cooper]

Copy cell properties doesn't seem to work correctly either, I am selecting a cell to copy to make a new one and it is not using the correct cell

Stu

I'm stumped.  Are you talking about copying a cell's Property Set?  As in the attached image?

[Stuart Murray]

Copy cell properties doesn't seem to work correctly either, I am selecting a cell to copy to make a new one and it is not using the correct cell

Stu

I'm stumped.  Are you talking about copying a cell's Property Set?  As in the attached image?

As below Corey.



Stu

[Corey Cooper]

Yikes, you are absolutely right, it always makes a copy of the first cell in the toolbox.  Thank you.  I will fix this.

By the way, I just finished the next overhaul of the Layout tab.  The Layout tab is now completely drag-and-drop enabled (as well as cut/copy/paste enabled).

[Magic_fubu]

Cool!  Should make it even easier to manipulate the cells