Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - CanopicJar

Pages: 1 ... 7 8 [9]
121
Well, I have tried shutting down all non-vital programs and still get the same issue.

When I right click on this blank screen and pick refresh, it goes ahead and loads but gives the Error in Line 104.  Any information on what line 104 is?

Thanks,
Travis

122
Help Me / Re: Help with automatic seating
« on: March 20, 2006, 11:05:25 AM »
I connect a projector to the laptop so that everyone can see the screen clearly.   ;D

123
I am really wanting to get upgraded to TD2 but cannot get past the blank ms-its screen.  I have tried the bugoff program and it says ms-its is enabled.  It also states that ms-itss is disabled but will not let me enable it.  Also if I right click on the blank ms-its screen, I can click refresh.  At that point the program loads up but gives an error at location 104, and then states that it must shut down at this time.

I have disabled the script-stopper in my McAfee anti-virus program.  TD1.3 runs fine.

Please Help!

Travis

124
General Discussion / Re: Rebuy's
« on: March 16, 2006, 09:28:44 PM »
no re-buy/no add-on

125
I am having this problem as well.  When I run bugoff, it states that all the programs in the list are already enabled (including ms-its) with the exception of the last program which is ms-itss.  ms-itss is disabled and when I click on enable, it will not allow it to enable. 

I would really appreciate any help I can get.

Thanks,
Travis

126
Help Me / Re: TD2 error
« on: March 14, 2006, 03:31:34 PM »
OK, I turned off the script-stopper in McAfee.  Now TD1.3xxx starts without the script prompt as before, but TD2 is still doing the same.

Travis

127
Help Me / Re: TD2 error
« on: March 14, 2006, 08:15:32 AM »
The first blank window that I get before I refresh is the ms-its window shown in another topic.  I ran the bug-off program and ms-its is enabled, but ms-itss is disabled.  When I click on Enable, it does nothing (it apparently cannot enable it).  I am running XPpro.  I use Firefox as a web browser and I have McAfee anti-virus. 

I believe that the problem is tied to McAfee because when I start TD1.3xxx, McAfee pops up a "suspicious script" warning and I have to allow the script to run each time.  If I can figure out how to work around that, the TD2 problem may disappear.

Thanks for your help,
Travis

128
Help Me / TD2 error
« on: March 13, 2006, 09:41:59 PM »
I am getting an error on line 104 when I try to start TD2.  When I first try to start the program, I get a blank box.  If I right click, I can select refresh and then it opens and I get the error.  Here is a screen capture of the error.



I used TD 1.3xxx last weekend for a home tourney and it really works great! 

Thanks for the help,
Travis

Pages: 1 ... 7 8 [9]